The Sweeper is constructed from pressed steel shell which give excellent strength to weight ratio. It is a tractor mount sweeper driven from the tractor PTO shaft and is available with small debris collector box and water spray equipment as optional. The sweeper is designed for use with almost any tractor which is fitted with hydraulic lift, three point linkage and power take off and can be fitted or detached in less than five minutes. Brush sections are supplied in crimped steel wire or polyproplyene and are easily replaceable. The castor wheels fitted to the rear enables the sweeper to follow road undulations. The sweeper may be used to sweep straight ahead (for collection) or in two angled positions either side. The splash guard fitted to the sweeper is easily removed the allow the collector attachment to be bolted into place.
- Steel wire, polypropylene or combination brush section.
- Rigid pressed steel shell.
- Easily adjusted for brush wear.
- Different lengths available to special order
- Optional water tank and sprinkler attachment.
Due to KDI Policy of continous improvement / development, the technical data mentioned in this entire sheet is not binding and subject to change without notice